DK Digital CDB-600 Especificaciones descargar pdf (Pagina 53)

MSD Software Manual PRELIMINARY Release Appendix A Hardware Specifications.

A.1.4 4 Channel Digital Input Module.

Type Number: MSD600M-Input-4D/O

Description: Input module with 4 digital inputs.

Supported by: MSD600M, MSD600M++, PT0600M, PT0660M, PT0660M-LS

Digital Inputs:

Quad AES-3 Input Module. The inputs are equipped with sample rate

converters to synchronize the inputs to the internal clock. The sample rate

converters may be by-passed. In this case the base unit should be

synchronized externally by an AES-3 signal applied to the sync input on the

utility connector.

Sample rate range: 30 Hz to 100 kHz

Internal sample rate: 48 kHz

Bit resolution: 16 bits

Group delay: maximum 1.75 msec

Passband ripple: ±0.008 dB

Total harmonic distortion and noise: typical –103 dB at 1 kHz

Dynamic range: larger than 120 dB

Nominal input impedance: 110 ohm

Possible placement: Priority A

, Input slot #1, #2, #3 and #4.

Modules with higher priority must be placed in input slots with a lower number, starting with input slot #1.

Modules with the same priority can be interchanged.

Connector type: 25 pin Female D-Sub

Pin Configuration:

PRELIMINARY Release Page 49 of 64

Signal Name. Pin number.

AES-3 Channel 1 Hot 2

Cold 9

Ground 1

AES-3 Channel 2 Hot 11

Cold 3

Ground 10

AES-3 Channel 3 Hot 15

Cold 8

Ground 7

AES-3 Channel 4 Hot 14

Cold 6

Ground 13

Ground 4

Ground 12

View from solder side of the 15 pin

MALE D-Sub connector.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

Sin comentarios

DK Digital CDB-600 Especificaciones Pagina 53